Installation guide

SkyView System Installation Guide - Revision R 5-1
5. SV-ADAHRS-200/201 Installation and Configuration
The SkyView ADAHRS module uses MEMS sensor technology to accurately measure inertial,
magnetic, and air data. To ensure accuracy in its readings, it is very important that you install
the module correctly and perform the specified calibration steps. This chapter guides you
through that process.
Dynon sells a primary ADAHRS model (SV-ADAHRS-200) and a backup model (SV-ADAHRS-201).
Throughout the guide, these models are collectively referred to as “SV-ADAHRS-200/201.” The
SV-ADAHRS-200 and SV-ADAHRS-201 are identical in functionality.
Read and understand the System Planning Chapter before installing the ADAHRS.
If you have more than one ADAHRS in your SkyView system, all ADAHRS
calibrations are applied to all ADAHRS simultaneously. In other words, you
generally only need to go these steps once per system, provided all ADAHRS are
calibrated, installed and are connected via SkyView Network. However, if an
additional SV-ADAHRS-200/201 is installed and configured at a time after the
original installation and calibrations in this chapter have been performed, all setup
and calibration steps in this section of the SkyView Installation manual should be
performed as if the ADAHRS is being installed for the first time.
Figure 24 is a high-level overview of a suggested and installation and configuration procedure
for the SV-ADAHRS-200/201:
Choose a
location based on
Location
Requirements
Section
Install SkyView
network cabling
Prepare the
location
Install AOA/Pitot
probe
Install static port
(not covered in
this guide)
Install pneumatic
plumbing
Install OAT probe
and wiring
Install ADAHRS
module with
electrical and
pneumatic
connections
Configure
ADAHRS-related
settings on
SkyView display*
Perform magnetic
calibration
Perform AOA
calibration
Reference
Accessory
Installation and
Configuration
Chapter
*Assumes SV-D700 or SV-D1000 is properly installed and working.
Configure
SkyView Network*