Installation guide

SV-ADAHRS-200/201 Installation and Configuration
SkyView System Installation Guide - Revision R 5-9
The values on this page are default values that act as placeholders. You must adjust these
values to work with your aircraft for any colors to show up on the IAS tape and also to be able to
calibrate the autopilot servos.
Vertical Speed Scale
Set the vertical speed scale on the Vertical Speed Scale Page (SETUP MENU > PFD SETUP >
VERTICAL SPEED SCALE).
G Meter
Go to this page (SETUP MENU > PFD SETUP > G METER) to configure the G meter.
The pop-up thresholds are G values that, when exceeded, will cause the G meter to display
automatically. The G meter replaces the HSI when it is displayed. In addition to popping up
automatically, the G meter can be manually toggled on and off using the PFD > G METER
button. If you do not want the G meter to ever be displayed automatically, set the positive pop-
up threshold value very high and the negative pop-up threshold value very low.
You can also set yellow and red cautionary ranges of the G meter here, and whether or not the
max/min recorded Gs are reset at each SkyView boot-up.
Synthetic Vision License
SkyView displays can be purchased with or without a license pre-installed that allows Synthetic
Vision to be shown. In order to display Synthetic Vision, each SkyView display must be
individually licensed to display it.
To check whether a display is licensed to display Synthetic Vision, go to SETUP MENU > LOCAL
DISPLAY SETUP > LICENSE, and look at the status of the SYNTHETIC VISION line. If it is licensed,
Synthetic Vision will be displayed as long as SkyView has a valid GPS position signal and has the
appropriate high resolution terrain database installed for the region of the world that you are
flying in. See the Terrain Data section of this manual for information about obtaining and
loading terrain data to SkyView (high resolution terrain data is available for free from Dynon
Avionics.)
To enable Synthetic Vision on displays that do not have it pre-installed, a license that allows a
single display to display Synthetic Vision can be purchased in one of two ways:
1. Call Dynon Avionics directly at 425-402-0433 with your SkyView display model (SV-D100
or SV-D700) and serial number (as displayed on the case sticker, or in SETUP MENU >
LOCAL DISPLAY SETUP > DISPLAY HARDWARE INFORMATION). A License Code can be
purchased for the particular display you wish to enable Synthetic Vision on. This six
character License Code is then entered in SETUP MENU > LOCAL DISPLAY SETUP >
LICENSE > LICENSE CODE.
2. A SkyView Synthetic Vision Certificate may be purchased from Dynon Avionics or any
authorized Dynon Avionics retailer. This certificate can be redeemed for a license code
that can be entered in SETUP MENU > LOCAL DISPLAY SETUP > LICENSE > LICENSE CODE
to enable Synthetic Vision. To redeem a certificate simply follow the instructions on the