User guide

SV-MAP-270 Navigation Mapping Software
7-28 SkyView Pilot’s User Guide - Revision Q
only targets) because they are not able to request traffic data from the FAA ADS-B ground
stations.
Tail numbers will be shown below traffic targets when available. These can only be
shown if your aircraft is equipped with Dynon's ADS-B receiver, and will only be
shown for target aircraft that are ADS-B OUT equipped. Aircraft with Mode-C
transponders or Mode-S transponders without extended squitter support will not
have tail numbers shown.
Although weather and TFR information are available any time the SV-ADSB-470 is in
an ADS-B ground station coverage area, ADS-B TIS-B traffic is only available if an
ADS-B Out capable transponder is installed and is providing ADS-B out position
reports into the ADS-B system. Currently, these are limited to the Dynon SV-XPNDR-
26X and the Garmin GTX-330ES.
Useful information about the ADS-B traffic and weather systems can be found in
the FAA AIM: http://www.faa.gov/air_traffic/publications/ATPubs/AIM/aim.pdf
For updated coverage maps see the FAA’s website:
http://www.faa.gov/nextgen/implementation/programs/adsb/
Traffic Target Information
Figure 91 - Traffic Target
Traffic is displayed using a set of symbols that are commonly used in aviation for traffic/TCAS
systems. As seen in Figure 91, this includes:
 A symbol that depicts the type of traffic. It can be a Traffic Advisory Symbol, Proximity
Advisory Symbol, or Non-Threat Symbol. These are further discussed later in this
section. Data being received by a TIS device, such as the SV-XPNDR-26X, is limited to 8
simultaneous targets by the inherent capability of the TIS system. If there are more than
8 traffic targets that are potential threats, the TIS ground station determines the highest
priority targets and transmits them to your aircraft.