User guide

COM Radio Operation
SkyView Pilot’s User Guide - Revision Q 10-5
 Turn the small, inner ring of the dual concentric knob to change the standby frequency
in 25 kHz increments.
o For example, if the frequency you start with is 123.450, turning the large knob
will change the numbers before the decimal – 123 – while the small knob will
adjust the numbers after the decimal – 450.
 Press the dual concentric knob on the control panel to flip/flop the chosen frequency
from the standby frequency to the active frequency.
Airport / Station Type Reverse-Lookup
When a frequency is manually tuned, SkyView will search for the closest known airport within
75 miles that has that frequency and automatically show that airport’s identifier in the
associated airport and station type fields on both the control panel and top bar.
For example, if you manually tune 118.300 near Seattle’s Boeing Field, the associated airport
will be shown as KBFI and the station type as TWR1.
Tuning Individual Frequencies from SkyView
To send an individual frequency from SkyView’s airport information pages:
 From SkyView, bring up the INFO page for an airport
 Then, use the joystick to select a frequency from under the COMS tab