User guide

Messages and Alerts
11-6 SkyView Pilot’s User Guide - Revision Q
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Warning”
DEMO MODE
System is in Dynon demo mode
and is not airworthy
“Warning”
PITCH SERVO
OFFLINE
The Pitch Autopilot servo has
stopped communicating with
SkyView. Will be seen if Autopilot
servos are not receiving power.
“Warning”
ROLL SERVO
OFFLINE
The Roll Autopilot servo has
stopped communicating with
SkyView. Will be seen if Autopilot
servos are not receiving power.
“Warning”
ARINC-429 OFFLINE
The SV-ARINC-429 module is not
communicating with SkyView.
“Warning”
BACKUP BATTERY
LOW
The backup battery connected to
this display is low.
“Warning”
SKYNET POWER
FAULT
A fault has been detected in the
wires that provide power to
SkyView Network devices.
“Check Canopy Latch”
Check Canopy Latch
A canopy latch alert is configured;
The canopy is not latched; and the
engine has been advanced past a
configured RPM.
“Caution”
STANDBY NETWORK
ERROR
SkyView Network has lost its
secondary standby network
redundancy. See below for more
information.
“Caution”
POSITION SOURCE
or GPS X FAIL
Position source (GPS) failure
“Caution”
TRANSPONDER FAIL
Transponder failure.
“Caution”
XPNDR GPS IN
OFFLINE
The certified GPS source (optional
connection) that normally
provides GPS position to the SV-
XPNDR-261 for ADS-B Out use is
offline.
“Caution”
BACKUP BATTERY IN
USE
System has switched to SkyView
Backup Battery.
“Caution”
OTHER DISPLAY
OFFLINE
A SkyView Display has failed or is
no longer communicating via
SkyView Network.
“Caution”
NEED COMPASS CAL
Magnetic compass heading is not
calibrated