Owner manual

ManualsBrandsValco Baby ManualsCarLatitude Peg Perego Adaptor

Thank you for purchasing a quality VALCO product. Please read and follow the instructions outlined in this

guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all

the warnings and safety guidelines before use. This product is for use with the VALCO Latitude stroller in North

American only. This product is not intended for use in Australia.

Important: Please read the following instructions carefully before assembling this product. Retain this

guide in a safe place for future reference.

PRODUCT REFERENCE GUIDE

Due to our policy of continuous

product development, this

product is constantly evolving. It

is possible that some features or

procedures outlined here have

changed since this document

was written. If you are unsure

of any procedure shown here,

please contact us via the web at

info@valcobaby.com to obtain

the most up to date information

before use. Include the batch

number, which can be found on a

sticker on the frame.

All pictures and diagrams herein

are provided for illustration

purposes only. Actual product,

colour or fabric may vary. VALCO

reserves the right to modify or

alter any specication or colour

without notice or obligation to

modify any product previously

purchased

FURTHER INFORMATION

North America only

www.valcobaby.com

1800 610 7850

Latitude Car Seat

Adapter

Compatible with most Peg Perego Car Seats

Summary of content (4 pages)

PAGE 1
Latitude Car Seat Adapter Compatible with most Peg Perego Car Seats PRODUCT REFERENCE GUIDE Thank you for purchasing a quality VALCO product. Please read and follow the instructions outlined in this guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all the warnings and safety guidelines before use. This product is for use with the Valco Latitude stroller in North American only. This product is not intended for use in Australia.
PAGE 2
1 A 2 installing your peg perego Car seat adaptor FIGURE A 1. Begin preparing the Latitude stroller for the Car Seat Adaptor by removing the canopy (hood), from the stroller, and reclining the seat to its fully reclined position, (detailed instructions in the Latitude Stroller Instruction Manual). Seat Reclined Bumper Bar B FIGURE B 2. Remove the bumper bar, (detailed instructions in the Latitude Stroller Instruction Manual). press C FIGURE C 3.
PAGE 3
4 E FIGURE E 6. Align an adapter connector piece with the corresponding raised piece on the stroller (where the hood connects) (4). 5 7. Slide the connector piece onto the stroller. Be sure that the adapter is locked into place (5). 8. Repeat on the other side. FIGURE F Press F 9. The Adaptor is now secured to the frame, with the support bar resting at the edge of the seat, above the footrest. 10. Adjust the footrest upwards.
PAGE 4
6 I FIGURE I 16. Once your car seat is inserted, locate the remaining set of straps. 7 17. Take the Male/Female strap and slip the strap through the car seat belt hook on the side of the car seat. 18. Repeat with the other strap. 19. Insert Male clip into its Female counterpart and buckle. 20. Adjust straps to tighten around car seat. To remove your car Seat: 21. Reverse the steps outlined in Figure I and lift out the car seat. To remove your adaptor: 22.