User guide

installing the eXpanda hOOds

FIGURE H

18. Identify left and right side hoods by determining that

the sliding housing (Image K) sits on the SIDE (a) of the

frame, and the puzzle housing (b) (Image J) rests on the

centre (c) of the stroller.

FIGURE I

Turn your stroller around to the back:

19. Place the rear hood skirt OVER the stabilizer bar at the

rear of the stroller (d).

FIGURE J

Turn your stroller around to the Front: [SEE IMAGE H (c)]

20. Insert the hood section (e) into the corresponding

housing (f) in the CENTRE of the seat.

FIGURE K

21. Place the other plastic hood housing above the

corresponding housing on the SIDE of the stroller. Be

sure that the frame locking strap is out of the way and

ABOVE the hood housing.

22. Align the raised track on the stroller housing with the

corresponding channel in the hood housing.

23. Slide the hood housing downward, engaging the track

in the channel, continue sliding downward until the rivet

outside (g) is fully engaged in the housing.

24. Repeat the procedure outlined in Figure J to K for the

other hood.

FIGURE L

25. Secure each hood to the rear of the frame with Velcro

straps at the centre (h), and both sides of the hood (i).