Installation Instructions

Electronic Hub Odometer User Guidance

How It works

Valcrum

Hub Odometer is an advanced mileage counter that monitors the earth‟s

gravity for recording wheel revolutions. The gravity acceleration directions and values

are collected and then calculated by the MCU to come out of the revolutions of the

wheel. With the tire size information inputted, the MCU work out the mileage of the

wheel and show it with an LCD display.

Program the Unit

Sleep Mode

The Unit shipping out factory is set in “Sleep Mode” and shows „REV 999.9

‟

This display indicates that the unit has NOT been programmed and activated.

It must be programmed before you use it for mileage recording.

Download APP to Your Cellphone

Valcrum electronic hub odometer does not need a dedicated programmer.

Any intelligent communication equipment, with Bluetooth 4.0 (or above) can be

used as a programmer.

Find this APP “WGCVS Hub Odometer” at App Store on your cellphone and install it.

(Figure 1)

Make Sure your cellphone Bluetooth is turned on when program a unit.

Step 1: Select Job

Normal Set: This is for programming of a new unit

Batch Set: For same tires, use the “Batch Set” menu to set all units at one time

Clear Trip: Mileage and Start a new trip. Trip mileage can be reset any time to start a new trip by activating

the Bluetooth of the unit and the “Clear Trip “menu

Step 2: Data Settings

Units: KM or Miles, the selected unit will apply for both Life mileage and Trip mileage

Staring Mileage: Set the mileage to match the current mileage of the vehicle the unit for. (Figure 3)

Tire: For the utmost accuracy, set the tire by Revolutions (preferred). Or select the tire size which are stocked

at the APP database. (Figure 4)

Figure 1

Figure 2

Figure 3

Figure 4

PAGE 1
Electronic Hub Odometer User Guidance How It works Valcrum ® Hub Odometer is an advanced mileage counter that monitors the earth‟s gravity for recording wheel revolutions. The gravity acceleration directions and values are collected and then calculated by the MCU to come out of the revolutions of the wheel. With the tire size information inputted, the MCU work out the mileage of the wheel and show it with an LCD display.
PAGE 2
Step 3: Program the unit  Make sure the cellphone Bluetooth is turn on (No pairing needed).  Activate the odometer by pushing the button for 2 seconds.  Select the Part ID on your cellphone to start Once “Syncing Succeeded”. Touching the button for FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.