User's Guide

Maintenance
Honda cannot guarantee the system’s operation if the system has been modified or if any added
on equipment has been installed to it. In case of a problem with the immobilizer system or the
key, consult an authorised Honda dealer.
FCC ID : N5F-A05IAA
FCC ID : N5F-A05TAA
IC: 3248A-A05IAA
IC: 3248A-A05TAA
These devices comply with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) These devices may not cause harmful interference and,
(2) These devices must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications made to these equipments not expressly approved by Honda may void
the FCC authorization to operate these equipments.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency radiation exposure Information:
The radiated output power of the device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact
during normal operation is minimized.