User Manual
5
•Only connect this unit to alternating current and check that the mains supply voltage
corresponds to that indicated on the unit.
•Never immerse this unit in water or other liquids.
•Do not put this unit down where it could fall into water or other liquids.
•Do not try to pull any electrical appliance out when it has fallen into water - disconnect
the plug from the power socket immediately.
•Make sure the unit is perfectly dry before using it.
•Do not put the appliance on heat sensitive surfaces during use.
•After use always switch the unit off and remove the plug from the power supply socket. Do
not pull on the wire to remove the plug from the power supply socket. Do not pull the plug
out of the power supply socket when your hands are wet.
•Always allow the unit to cool before putting it away and never wrap the cord around the unit.
•Check that the cord has not been damaged from time to time.
•Prevent the cord from coming into contact with the metal parts while these are still hot.
•Use the unit on dry hair.
•Do not use this unit on wigs that have synthetic hair.
•Do not use your unit if it is not working properly. Do not try to repair this electrical unit
yourself, rather contact an authorized technician.
•The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of
reach of children as they are a potential danger to them.
•This unit must only be used for the purposes for which it is expressly intended. Any other
use is to be considered improper and therefore dangerous. The manufacturer accepts no
responsibility for damage caused by improper or erroneous use.
•Do not use hair spray while the unit is running.
•Keep the plates clean and free of dust, hair spray, styling gel, etc.
•To avoid dangerous overheating, it is advisable to unwind the entire length of the cord.
OPERATING INSTRUCTIONS
1 Curling iron
2 ON/OFF button
3 Temperature selection buttons
4 Ready indicator
5 Display
Switching the unit on and selecting temperature
1. Insert the power plug into the socket.
2. Press and hold the ON/OFF button (2) for approximately 2 seconds. The display (5) will
indicate the temperature (6).
3. Use the buttons (3) to select the temperature you require.
4. Before using the appliance, leave the iron heat up until the ready indicator (4) stops flashing,
indicating that the set temperature has been reached.
It is possible to select 4 different temperature levels:
• 100°C for fine, straight hair
• 130°C for fine, wavy hair
• 160°C for thick hair
• 190°C for thick, curly hair
5. To turn the unit off, press and hold the ON/OFF button (2) for approximately 2 seconds, then
remove the plug from the power socket.
Important: Never leave the appliance unattended when it is turned on.
Always use the stand (9) to rest the hot appliance.
This appliance has a safety timer that turns it off automatically 1 hour after it has been turned
on; the time that has passed is indicated on the display (5) by 6 bars (7), which turn off
progressively at intervals of approximately 10 minutes (fig. 1).
To turn the appliance on again, see “Switching the unit on” point 2.
OPERATING TIPS
•This appliance has been designed to curl your hair, leaving it full of shine.
•Hair that has just been washed and dried can be styled better.
•The first few times you use this unit it is advisable to practice on small areas of your hair.
•The effect obtained depends on how thick and how long your hair is as well as curling time.
Start by using a curling time of 10-20 seconds.
•To make the appliance easier to use, hold the cold end (10) of the iron with your free hand.
6 Temperature setting
7 Timer indicator
8 Hair clip
9 Stand
10 Cold end
00060509 digicurl int giu2013 11/06/2013 12.58 Pagina 5