User's Manual

-Confidential-

Valerann R&D

Valerann Smart road system – User manual

REV01.1

1. General

a) The following describes the method for installing and operating Valerann’s

Smart road system, comprising of road stud sensors and road-side

communication gateway. This system configurated without the presence of

Valerann’s cloud-based server.

b) The entire system is pre-configured. Therefore, once the devices (i.e. the stud

and gateway) are connected, the system will start running automatically.

c) The protocol applies to AS3100 gateway and AS2200 road stud (see figure 1+2).

2. Procedure:

a) Power-up the road studs by removing the battery-cutoff-magnet at the

bottom of the unit (will be done by Valerann personnel):

b) Install the gateway on near-by pole and connect its power cables

according to “Valerann Gateway - Installation Protocol - REV02”

Figure 2- AS2200 Smart road stud sensor unit

Figure 1- AS3100 - Roadside

communication gateway

PAGE 1
-Confidential- Valerann R&D Valerann Smart road system – User manual REV01.1 1. General a) The following describes the method for installing and operating Valerann’s Smart road system, comprising of road stud sensors and road-side communication gateway. This system configurated without the presence of Valerann’s cloud-based server. b) The entire system is pre-configured. Therefore, once the devices (i.e. the stud and gateway) are connected, the system will start running automatically.
PAGE 2
-Confidential- Valerann R&D c) Install the road studs according to “Valerann Smart Road Stud Installation Protocol - REV04” d) At that point, the system should run and save the data from the road at the gateway memory. 3. Data extraction: a) Extract the gateway’s memory (on the back of the Odroid CPU board): b) Connect the memory to Odroid’s SD adaptor: c) Connect the SD adaptor to an SD card reader and extract the data to a PC. 4.
PAGE 3
-Confidential- Valerann R&D liabilities. Valerann and its resellers or distributors are not liable for injury, damage or violation of regulations associated with the installation of outdoor units or antennas. c) This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.