User's Manual

-Confidential-

Valerann R&D

liabilities. Valerann and its resellers or distributors are not liable for injury,

damage or violation of regulations associated with the installation of outdoor

units or antennas.

c) This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment.

d) The antenna used for stud sensor transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be co-located

or operating in conjunction with any other antenna or transmitter.

e) This device complies with FCC Rules Part 15. Operation is subject to two

conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference that may be received or that may cause

undesired operation.

f) Changes or modifications to this equipment not expressly approved by the party

responsible for compliance (Valerann Ltd.) could void the user’s authority to

operate the equipment.

g) This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.