Skirted and Dropin Alcove Tubs Install Guide

1 Framing
2 Wall covering
3 Sealant
4 Optional metal clip
5 Bathtub
6 Wood stud 1”x3” standard (3/4” x 2 1/2”)
7 Integrated tiling flange
2
1
3
5
6
4
7
7
2
1
3
4
5
2
1
3
4
5
7
Incline the support as required to allow easy installation.
The bathtub cannot be supported by the wood under the tiling flange as it is not designed to carry the
weight of the bathtub. Rather, your bathtub should be supported by the wood studs, and the floor; using
wood shims if necessary.
Connect plumbing (drain, overflow, faucets, etc.) according the local standards, and using the general rules
found in this guide. Ensure that all plumbing joints have waterproof seals before use.
Note: The apron, and if applicable, the wall, must be installed before proceeding to the finish.
Install your wall finish around the bathtub. The wall finish should overlap the integrated tiling flange (2). Seal
the joint between the bathtub and wall finish with a bead of silicone (3).
Finishing up
Install the finish covering over the island, and fill the joints with a silicone sealant.
Construct the alcove in accordance with Fig. A using your tub dimensions.
NOTE: Structure measurements must be verified against your actual unit to ensure a proper fit.
Install a standard 1” x 3” piece of wood (not provided with your product) [3/4” x 2 1/2” | 2 cm x 6.3 cm] all
around the alcove, at height C (Fig A). The 1” x 3” must be cut down to 1 1/4” inside dimension B (Fig A).
Install, and level the bathtub within the alcove, and secure vertical supports along the front of the bathtub
(See diagram below).
Note: Leave a space in front of the supports to allow space for the apron, if applicable to your product.
Ensure that these vertical supports do not press on any jets or piping you may have installed.
Connecting the plumbing
Connect the plumbing (drain,
overflow, faucets, etc.)
according to local building
codes, and keep to the
general rules in this guide.
Make sure that all joints are
waterproof. Fill up the
bathtub with water to
inspect for leaks.
5
6