Owner`s manual

34
Fold Lines
Other side standoffs
Outlet side standoffs
Only qualifi ed licensed or trained personnel
should install this appliance.
Installation
Unpack appliance
Beware of sharp edges! Wear gloves!
1. Remove the cardboard wrapping and the wood
pallet from the appliance and discard.
2. Unpack any loose items from around the appliance.
3. Verify that you have all the components required
for the installation, including:
- approved non-combustible cement board;
- liners and fuel bed (in separate cartons);
- trim kit with barrier screen;
- venting components and accessories.
Fit Stand-offs
1. The four top stand-offs are supplied fl at on the
fi rebox and fi xed at one end. Bend them as shown
and fi x the loose end to the top of the fi rebox.
2. The The four side stand-offs are supplied fl at. Bend
them and fi x them to the sides of the fi rebox as
indicated with the screws supplied (2 stand-offs per
side).
Installer—READ THIS FIRST
1. YOU NEED TO KNOW FROM THE
HOMEOWNER:
- The height of the unit and hearth if used;
- The thickness and type of the wall fi nish
around the fi rebox opening;
- What accessories (trim, etc.) will be installed
with this fi replace;
- The venting confi guration.
2. Unpack the appliance, removing all items packed
inside and around the appliance.
3. Check that you have everything, using the Pack
Content sheet. Also, check that you have:
◊ a fuel bed (logs, glass) (packed separately)
◊ a set of liners (packed separately)
4. Install the top and side stand-offs to the appliance.
5. Finish the framing.
6. Fit the appliance into framing and fi x it to the
framing.
7. Remove the window on the valve access side of
the appliance.
8. Install the venting system and tape vent pipe joints.
9. Position the restrictor.
10. Connect and test the gas supply.
11. Install the liners.
12. Install the middle platform supports.
13. Install the fuel bed.
14. Refi t the window and the hot glass safety plate if
removed.
15. Install the control wall switch kit.
16. Initialize the remote control system.
17. Verify the operation and adjust aeration settings.
18. Install the remote control handset wall holder.
19. Instruct the homeowner on the operation and
maintenance of the fi replace.
20. Finish the wall around the fi replace.
21. Install the surround trim and barrier screen.
Installation Planning
QUALIFIED
INSTALLER