Operating instructions

18
Appliance Preparation
Fit the pipe and connector supplied with the engine to the valve. Connect the gas line to
the inlet pipe.
3/8” gas line
connection
5/16” fl are
Gas Pipe &
Connector
Fixing
Casting Side
Panels &
Engine
1. Adjust the position of the engine to locate the top and bottom screws of the side panels
into the slots of the engine’s side bracket. Tighten the top and bottom screws.
2. Adjust the engine as required and fi x it to the casting base at bottom of its side
brackets with the nuts and bolts provided.
Receiver hooked to burner pipes
Lighting
Instructions
Plate
The lighting instructions plate is attached to the back of the engine and may have slid out
of its slot. Reposition the plate if this is the case.
Remote
Control
Receiver
Under the engine, the receiver box is clipped to the burner pipes to facilitate transportation.
Unclip the box and let it hang while you fi t the gas pipe.