Owner`s manual

Overview
This appliance may ONLY be installed in an existing unaltered,
functioning solid-fuel burning fi replace with a working fl ue and
constructed of non-combustible material.
DO NOT install into combustible construction. This appliance
is NOT APPROVED for installation with a zero clearance kit.
785 fi replace
Chimney Terminal Cap
Flashing
2 x 3” approved
fl ex chimney liners
running full length
Existing unaltered,
functioning solid-fuel
burning fi replace &
chimney
Existing non-combustible
hearth as required for
existing solid-fuel burning
fi replaces. Combustible
hearths or fl oors must
be mininum 4” (102 mm)
below bottom of heater.
Trim
(sold separately)
WARNING
HOT HEARTH / FLOOR!
HOT HEARTH / FLOOR!
The
The
hearth or fl oor in front of the fi re-
hearth or fl oor in front of the fi re-
place may become very hot when
place may become very hot when
the fi replace heats. Do not use the
the fi replace heats. Do not use the
hearth as a seat or shelf. Solid wood
hearth as a seat or shelf. Solid wood
fl ooring in front of the fi replace (if
fl ooring in front of the fi replace (if
allowed) may shrink during the heat-
allowed) may shrink during the heat-
ing season due to heat.
ing season due to heat.
WARNING
Some materials or items, although
Some materials or items, although
safe, may discolor, shrink, warp,
safe, may discolor, shrink, warp,
crack, peel, and so on because of
crack, peel, and so on because of
the heat produced by the fi replace.
the heat produced by the fi replace.
Avoid placing candles, paintings,
Avoid placing candles, paintings,
photos, and other items sensitive to
photos, and other items sensitive to
heat around the fi replace.
heat around the fi replace.
WARNING
!
WARNING
!
17
QUALIFIED
INSTALLER