Owner`s manual

Front view,
left side
Top view, left side
Flex connector redirected using one elbow.
Flex connector redirected using two elbows.
Common fi ttings required (not supplied)
3/8” elbow
+ short 3/8”
nipple
OR
3/8” street
elbow(s)
(where al-
lowed)
1. Remove fl ex connector.
2. Remove fl ared connector.
3. Install new inlet elbow.
4. Add fl ared connector to new
elbow and fi t fl ex connector.
Close the access panel.
Alternate Inlet Connection
In cases where local codes do not permit the fl ex
connector to be used inside the appliance case,
reconnect the fl ex connector outside of the appliance
case. A cut-out is provided in the appliance case for
this purpose.
Cut-out
Option 1
Option 2
4. Add another elbow, the fl ared
connector and refi t the fl ex
connector. Direct it towards
the rear of the appliance or
downward.
Close the access panel.
Supply Gas Installation
Use common elbow and fi ttings (not
supplied) to redirect the position of
the fl ex connector. NOTE: the fl ex
connector bend radius must be no
smaller than the size of a golf ball
(approx. 1-3/4” or 44 mm).
26
QUALIFIED
INSTALLER