Owner`s manual

3/8” elbow

+ short

3/8” nipple

3/8” street elbow(s)

(where allowed)

6-3/8”

(162 mm)

13-1/4”

(337 mm)

Inlet Connection

The appliance is sup-

plied with a ﬂ ared elbow

connector ﬁ tted onto the

valve and a ﬂ ex connec-

tor supplied loose to be

attached to the elbow

connector. To facilitate

the installation of the ﬂ ex

connector, remove the

valve access panel on

the left side of the appli-

ance case.

NOTE: the ﬂ ex

connector minimum

bend radius must be no

smaller than the size of a

golf ball (approx. 1-3/4” or 44 mm) as indicated.

Alternate Inlet Connection

When the ﬁ replace opening width is too narrow, you

may use common elbows and ﬁ ttings (not supplied) to

redirect the position of the ﬂ ex connector closer to the

side of the appliance.

1. Remove elbow connector.

2. Install alternate elbow (not supplied).

3. Re-install original supplied connector elbow.

4. Install the ﬂ ex connector to the alternate elbow.

Gas

line exit

Installation

QUALIFIED

INSTALLER