Owner`s manual

21
Appliance Preparation
Venting Outlet
If the appliance is to be vented from the top, it is ready
for vent installation once the engine is on the casting
base.
If the appliance is to be vented from the rear, it must be
converted. Follow these simple steps:
1. Remove the following parts in this order:
a) Dura-Vent collar, gasket and intake plate from
the top of the appliance (22 screws of the intake
plate and 2 rear screws of the collar);
b) Exhaust collar (8 screws).
NOTE: The gaskets are glued to the engine or
the intake plate; it is not necessary to separate
them from the parts they are attached to.
However, if they need to be manipulated, BE
CAREFUL not to damage them because their
material is fragile.
2. Re-install through the vent opening at the rear of the
fi rebox in the reverse order in which you took the
parts out.
Co-linear Applications (Rear Outlet ONLY)
For conversion of rear outlet collar to co-linear
(two 3-inch pipes) rear venting, refer to instructions
packaged with the 556CLA Co-linear Adapter.
NOTE: Co-linear venting may only be installed into
solid-fuel burning fi replaces and chimneys.
Top Spar
1. Position the top spar on the side brackets located
between the engine and the cast sides.
2. Fix the spar with four 3/8” pre-assembled screws
provided.
The instructions in this manual cover installation
of the Madrona Traditional Stove (MF28 engine
+ MFCS01 or MFCS02 Traditional Castings).
For installation of the Madrona Contemporary
Stove (MF28 engine + MFCS04), use this
manual jointly with the instruction manual
provided with the MFCS04 kit.
INSTALLATION