Owner`s manual

24
Window Refi tting
x 4
To refi t the window, place it on the fi rebox frame and
hold it in place while pushing and turning its fastening
studs 90 degrees.
Then, apply light hand pressure
against the window frame sides to
bed-in the window seal.
If the Hot Glass Warning plate
has been removed from the front
lower corner of the window,
reinstall it by sliding it between
the glass and the frame as
indicated.
Remote Control Initial Set-up
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver’s
reset button until you hear one short and one long
beeps. After the second beep, release the reset
button.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
IMPORTANT: To ensure a safe operation, verify
that the studs are fastened properly to the
window tabs; then, pull out the top of the window
and release it to insure the springs return it.
Hot Glass Warning Plate
INSTALLATION