Owner`s manual

29
Owner’s Information
To refi t the window:
1. Place it on its frame and hold it in place while
pushing and turning its fastening studs 90 degrees.
Then, apply light hand pressure against the window
frame sides to bed-in the window seal.
2. Re-hook the cast front.
3. Reinstall the barrier screen by inserting fi rst the top
clip in the arch of the front and then pushing on the
side of the screen so that the clips snap into place.
The barrier screen and matte cast casing can be
brushed clean. The enameled cast casing can be
cleaned with mild soap and water then dried with a lint-
free soft cloth. Dust can be brushed from the ceramic
logs and fi rebox walls after removing the front unit and
opening the window. Dust can also be removed from
the burner using a soft brush after removing the ce-
ramic logs. When cleaning, make sure that no particles
are brushed into the slots of the burner.
Checks
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at
least 30 minutes. The pilot fl ame must cover the tip
of the thermocouple probe. The main burner fl ame
pattern will vary from appliance to appliance depending
on the type of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Batteries
Low battery signal: see page 34.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver and one 9 V alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should
the batteries lose power, the control may be operated
by manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver, pull the clipped receiver off the cross beam,
replace the batteries and clip it back to the cross beam.
Touch Up Paint
If you need to touch up the paint on your cast unit, use
the Stove Bright by Forrest 1990 Satin Black spray
paint. Please note that it may be necessary to spray
the entire cast piece.
CAUTION
To avoid short-circuit to the receiver, position the
antenna so that it DOES NOT TOUCH the ignition
wire.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
Correct Flame Picture
Thermocouple
probe must be
in flame
Pilot Flame can be
seen between logs
Pilot fl ame
WARNING
DO NOT TOUCH THE BARRIER SCREEN OR
DO NOT TOUCH THE BARRIER SCREEN OR
STOVE WHILE THEY ARE HOT!
STOVE WHILE THEY ARE HOT!
Let the stove
Let the stove
cool first before cleaning it.
cool first before cleaning it.
FOR SAFETY PURPOSE, ensure the barrier
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the stove front
screen is re-installed on the stove front
after maintenance.
after maintenance.
!
!
OWNER’S INFO