Owner`s manual

13
Firebox Installation
Reach Through Front
to Connect Liners
Reach Through
Top or Sides
to Connect Liners
Gear Clamps
Connection of liners to fi rebox
Trim liners if necessary and connect to the fi rebox either while the fi rebox is on the hearth or with the fi rebox in the
cavity. Use gear clamps provided to connect the liners to the fi rebox. If the liners are connected with the fi rebox on
the hearth, it will be necessary to pull the slack liner up from the top of the chimney after the fi rebox is installed.
Option 1 - Connect liners with
Firebox on Hearth
Option 2 - Connect Liners
in Fireplace
Support Legs Reinstallation (if removed)
With the fi rebox recessed behind the smoke curtain of the existing fi replace, raise the fi rebox and place the
individual support legs under the fi rebox. Placing a temporary shim under the fi rebox, such as a 2” x 4”, may help
while positioning the support legs. Tabs are provided on the support legs to help position them. Fasten the support
legs at the points indicated by the arrows using the bolts provided (2 per side).
Thread thumbscrews
into Support Leg.
Raise left hand side of firebox
and slip LH Support Leg
Under. Fasten with 2 bolts
as indicated.
Thread thumbscrews
into Support Leg.
Raise right side of firebox
and slip RH Support Leg
Under. Fasten with 2 bolts
as indicated.