Owner`s manual

14
Firebox Installation
Burner Module Reinstallation
Note: If the circulating fan is to be installed it should be done at this point before installing the burner
module. See instructions packaged with the fan for details of the fan installation.
Reinstall the burner module using the 10 screws removed previously. Note: The upper baffl e may be removed to
gain more room for the screwdriver to install the rear screws.
Reinstall Burner
Module
(10 screws)
Edge Fits Into
Cleat at Back
Remove Top Baffle
(2 screws)
(to provide space for a screwdriver)
Remove Top Baffle (optional)
Leveling the fi rebox in the hearth
The backside of each support leg has a leveling bolt. If necessary, adjust the level of the fi rebox in the hearth.
Leveling
bolt
Front View
Side View
Fret bracket
Leg
Leveling bolt
BackFront
Leveling
bolt
Gas Line Connection and Fire Unit Testing
Connect the gas line to the burner module. Check for leaks, purge the line, and test-fi re the unit before installing
the window or proceeding with the remainder of the install—see section Lighting Instructions.
Top Baffl e Reinstallation (if removed)
Edge Fits Into
Cleat at Back
Reinstall Top Baffle
(2 screws)