Owner`s manual

17
Remote Control Installation
Caution! Don’t connect the batteries to the remote control receiver until the
wires are connected to the burner control unit, as short-circuit could result in
destruction of the electrical components.
Connect the wiring harness to the receiver box, by pushing the wire connector
on to the receiver circuit board. The plug will only go on one way so please
ensure that the wires are pointing up and slot in the board is in line with the
tab on the wiring harness plug.
Connect wires as shown. Please note that the “L” connectors are different
sizes, the smaller one fi ts to the lower connection and the larger one the
top connection on the top left hand side of the valve. The other two wire
connectors can be fi tted to either terminal located to the left of the fl ame
control button.
Remove the remote control receiver lid.
Fit four AA 1.5 V batteries.
Place the remote control receiver on the base of the fi replace beside the
valve.
Fit the 9 V battery to the handset transmitter.
Remote control operating instructions are on pages 19–20 of this manual and are supplied with the remote
control kit.
1.
2.
3.
4.
5.
6.
Remote Receiver
Receiver Valve
Push-on
Connector
Window Refi tting and Checking
Hook the window over the top edge of the fi rebox,
and fasten the bottom two spring loaded bolts by
pushing in and turning 90 degrees. Check that the
window moves freely against the spring by pulling
out at the bottom. If broken, the window may only
be replaced as a complete unit as supplied by the
manufacturer.
Note: To remove the window, the cast iron
fret and fret retainers will need to be removed
fi rst—see section Cast Iron Fret Installation.
Check that Window
Moves Freely After
Reinstallation
Spring Loaded
Fastening Studs (2)
1/4 Turn