Owner`s manual

Owner’s Information

Automatic ON/OFF

You can set your ﬁ replace to come on before you wake up and turn off after you

leave and then, turn on again just before you come home and turn off after going

to bed.

You can leave it like this for the heating season.

Decide what temperature you want your ﬁ replace to be at. Also, decide what

time you want your ﬁ replace to turn on and off. Finally, decide what time you

want it to come back on and off in the afternoon or evening. For the ﬁ rst few

times you set the timer, it’s handy to write these times down.

Set the temperature (just as you did in the section Setting the Temperature.)

Press the TIMER button and hold it until P1

☼ appears and flashes. Let go.

While ﬂ ashing, push the buttons▲ (hour) and ▼ (minutes) to set the time at

which you want your ﬁ replace to turn on in the morning.

Press the TIMER button and hold it until P1 ☽ appears and ﬂ ashes. Let go.

While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at

which you want your ﬁ replace to turn off when you leave.

Press the

TIMER button and hold it until P2 ☼ appears and ﬂ ashes. Let go.

While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at

which you want your ﬁ replace will turn back on in the afternoon.

Press the TIMER button and hold it until P2 ☽ appears and ﬂ ashes. Let go.

While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at

which you want your ﬁ replace to turn off in the evening.

Note: If you want to set your ﬁ replace for only one time on and off, set P2

☼ and

P2 ☽ for the same times as P1 ☽. The remote will record the P1 ☽ off time for

both P2 times.

To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go back

to manual settings. Press TIMER to go back to your settings.

When your remote control displays BATT, you need to replace the battery with a

new 9 volt alkaline battery—6LR61/MN1604.