Owner's Manual

ManualsBrandsValor ManualsCar Audio & VideoRM-900W

Table Of Contents

Owners Manual

RM-900W

9-lnch Filp-down TFT LCD Monitor

(j)

9 •

TFT

LCD MONITOR

RM-900W

.....

;:;::~;::::<:.::

:,:c,i:~;';:':';l

ii/T,::;

,c."

OWAefr:St;,~~,"

Summary of content (8 pages)

PAGE 1
RM-900W 9-lnch Filp-down TFT LCD Monitor (j) (j) 9 • TFT LCD MONITOR RM-900W , ..... ;:;::~;::::<:.:: :,:c,i:~;';:':';l ii/T,::; ,c." ..
PAGE 2
PRODUCT SPECIFICATION Screen Size 9-lnch (16:9) Pixel Resolution 640x(RGB)x234 Brightness 250cd/m Contrast 300:1 Viewing angel (L/RITIB): 70170/65/65 Operating Supply 11-15V (Typical: DC 12V) Power Consumption 6W Standby Power Consumption 160 rnA Storage temp -40·C-85·C Video Output Level 1Vp-p, 75 Q (COMPOSITE) Video Input Level 1Vp-p, 75 Q (COMPOSITE) Audio Input Level 300mV 1 47Kohm Function IR-J FM_ TV_ SD_ USB Port_ Usable CD Format ------ Input 2 video and 2 audio(dual tra
PAGE 3
SAFETY PRECAUTIONS This is an important safety information,Please read all instructions before using the unit to help to prevent any accident and danger and to ensure the proper usage. Please keep safety note in an area that is visible to the user. Safety precautions are divided into two categories "warning" and "caution" and its meaning is right below this safety message.
PAGE 4
,&CAunON The device setup should be entrusted to an expert technician. -Please refer to the connecting diagram in the owner's manual, distribute wires entrusted to an expert if it is necessary. Do not use this product when the engine is turned on. -it may damage the battery and cause engine start up failure. Proper safety volume level operation. -Volume level for a unit operation should be at a level where no one can hear the systerm audio at the extenior of the vehicle.
PAGE 5
NAME AND FUNCTION OF EACH PART Monitor •• 808. CD e V1N2: Switch AV1/AV2 6 - : Analog decrease 8 MENU: Menu e + :Analog increase o t!J : Power ON/OFF o MONITOR OPEN BUTTON Monitor FLIP UP / DOWN o Lamp Switch Lamp ON/DOOR/OFF C) REMOTE CONTROL IR CD IR Transmitter ~ Lamp RM·900W ~ EARPHONE jack 4& AV2 input Remote Control / Kev Map 01 Remote Control Function U ..
PAGE 6
OPERATING INSTRUCTIONS • Turn the monitor on/off using the POWER button; • Press MENU button each time, submenu will appear ... , • button of remote control or + ,- button of monitor to scroll • Press VIDEO SELECT button of remote control or V1N2 button of monitor to switch AV1/AV2. • Press MODE SELECT button of remote control to switch picture mode(16:9/4:3).
PAGE 7
INSTALLATION Please make sure of suitability of the configuration and the size. Use the suitable accessories and tools for installation or disassembling. -~ ~~ ~"\\ ,.:..-::-,.:..':y> f \ \ : ~,i ~)2 \ 3 (1) First of all, unscrew the four screws on the mounting plate connected to the unit and take off the mounting plate. (2) Fixup the mounting plate on the suitable position of the vehicle with four screws. (3) Then install the unit with four screws on the mounting plate to fix the unit.
PAGE 8
PRECAUTIONS FOR SAFETY & , • . • Make sure to read the "manual" for safety precautions before installing unit or accessories Do not install unit in location where may obstruct or cause injury to driver or passengers, While driving under normal driving conditions.