Full Product Manual

5. Drill the 2 screw holes with a

6mm bit suitable for the wall

surface.

6. Install the anchors(Part #20),

Seal the wall around the nipple

and the anchors with waterproof

silicone.

7. After anchor screws have been

installed, affix the Positioning &

Support Brackets (Part #21) using

supplied Screws (Part #19).

Silicone

20 x2PCS

1 9 x2PCS

Note: Before drilling make sure you have the correct drill bit for your shower surface.

8. Hose shearing instructions

a. Grasping the PVC supply line, extend the PVC supply line straight over the shower head outlet.

b. Mark the PVC supply line where it intersects the bottom of the shower head outlet.

c. Shear the excess PVC supply line at the mark.

INSTALLATION INSTRUCTIONS

Method 1

- 10 -

Warning: Ensure your shower water

line is not directly behind the drilling

points A and B. Drilling into the water

supply line may cause extensive

damage.

Shear

Line 1