Installation Guide

• After all connections have been completed

inside the shower panel, it is ready to be

hung on the shower wall for installation.

• Raise the shower panel and bringing it to the

surface of the shower wall and gently lower

it until the bracket support struts on the back

of the shower panel meet the support brackets

( Part 14) installed in Step 10. Please ensure the

brackets (Part 14) are centered on the groove

on the support struts.

• Once a snug and secure fit is achieved and all

parts of the PVC Supply Line are secured to the

back of the shower panel, silicone sealant can

be applied to seal the gap between the shower

panel casing and the shower wall to hold it in

place and prevent water from entering behind

the panel.

1. Peel off the paper backing to the adhesive ring

for the Base Plate cover (Part 5).

2. Place the adhesive side to the wall and apply

pressure to secure the Base Plate Cover

(Part 5). (Note: Remove all residues to insure

the cover will bond properly)

3. Add a Filter Gasket (Part 11) into Elbow Joint

(Part 3) first.Then attach the Elbow Joint (Part 3)

to the Brass Extender Joint (Part 4), turn clock

wise to tighten.

4. Place the Showerhead Cover (Part 2) to

conceal plumbing fixture.

NOTE: If the water outlet is below 33.38” on the template, the PVC cover is not required.

INSTALLATION INSTRUCTIONS

- 11 -