Installation Guide

• Before Installation, insure there is sufficient
clearance to accommodate the shower panel.
A minimum of 28” is required between the
shower outlet and top of your existing valve.
Maximum clearance required 42”.
Ensure that the water line to the overhead
shower pipe is completely shut off prior to
performing any work.
• Remove the existing shower head and show
head arm.
• Connect the Brass Extender Joint (Part 4)
we provided to the showerhead pipe outlet.
Use waterproof plumbing tape on the thread
prior to securing the extender to prevent leaks.
(Note: There are 2 sizes of the brass extender.
Choose the appropriate size).
INSTALLATION INSTRUCTIONS
½" diameter is needed to
accommodate the shower panel's
Brass Extender Joint (Part 4)
- 6 -
MIN 28 Inch