Installation Guide

• Use the drill with correct indicated sized drill
bit to drill each of the 4 holes as marked in
step 6. Do not drill too deep a hole - only
enough depth to fully enclose the anchor
screws. Note: Please double check to ensure
there is no existing water pipes or obstruction
behind area you are drilling. If there is an
obstruction, you will need to reposition the
template guide to avoid it.
• After holes have been drilled, insert the
provided Anchor Screws (Part 15).
• To ensure the template (and your shower panel)
will be in a completely straight and level position,
use a level tool against the side of the template
guide to make fine adjustments to the template
guide's position until fully level.
• Once fully level, this will be the final position of
the template guide.
• Take a pencil/marker and mark the positions of
the anchor screws (Part 15) for which 4 holes
will need to be drilled.
9
7
8
15 x4PCS
INSTALLATION INSTRUCTIONS
- 9 -