Installation Instructions

STEP FOUR: INSTALL BASE AND TALL CABINETS
Important Note 6: Before installing any of these cabinets, be sure to measure, mark and cut openings for plumbing, power sources and other utilities.
sTART IN ThE CoRNER
• Startinstallingbasecabinetsinthecorner.
• Mountthecornercabinettothewallusingthemarkedhorizontallinesetat341/2”upfromnishedoor.It
mayneedtobeshimmedtoalignwiththelevelline.Checkthatthecabinetislevelandplumbbeforeinstalling
tothestudsinthewall.
• Ifcornerisabarrellazysusana1”x2”woodstripmustbeplacedat341/2”linetosupportcountertop.
• Besurethatstartingcornercabinetissquaretobothwallstoinsureatrue90°cornerandastraightlinefor
remainingcabinets.
ATTACh BAsE CABINETs
• Usingclamps,alignandjointhecabinetsatthebaseframes.
• Attachfaceframesthesamewayaswallcabinets,pre-drillingtwiceandusingthree-#8x21/2”panhead
screws.
• Shimtollunevenareas:
 •Betweenwallandbackofcabinet
 •Betweenoorandbottomofbase
 •Usinga48”or60”levelplacedhorizontallyagainstthefront/topfaceframewilltellyouifcabinetsare
straightandwhereshimsmustbeused.Thiswillalsokeepyourcabinetsinastraightline.
• Failuretodothiscanresultindamagetothecabinetiftightenedtowallwithoutshimstokeepcabinetface
framesstraightandlevel.
• Attachthebasecabinetstothewallthesamewayasthewallcabinets.
• Whenfaceframesofbothcabinetsareattachedtogetherandstraight,thenattachtowall.
• Checkcabinettoseeifitislevelandplumb.
STEP FOUR: INSTALL BASE AND TALL CABINETS