PRODUCT LIST T* Un-assembledleprechaun Pro. KIT Wood sheet pack™1 11 Plan™ Balsa stick these for each size Operation instruction™ Complete congeries bag™ FEATURES « Complete air frame KIT. « The design is derived from the classics vintage gliders. « Extremely lightweight, state-of-the-art almost-balsa construction. «Everything needed fo build the basis air frame of the model. « Extensive clear full size planes-and instructions. » Only adhesives and coverings are required to complete the air frame.
BUILDING INSTRUCTION 1 Fuselage frame assembly {1} Extend the BX8 balsa strips and fixed them according to the position an the full size plan. (2 } Glue balsa strips of the fuselage, vertical (8X8mm), obligus(8X8mim). { 3} Strengthen the nose part with Brim balsa strip. Pay attention fo the symmetrical adhesion on both sides of the fuselage.
{8} Glue the balsa pieces numbered A10 on the tall. {OY Glue ths motor men numbered AT inside. [10] Glue Ad into the fuselage, and combine and glue the wing joint parts: then glue ton According tithe position marked on Ad Make sure the ingesting line between the two vertices of the"V" wing joint be horizontal, { 11) Glue bulkhead numbered AB to the fuselage, and glue the two wing ribs numbered AS as the wing support.
{ 12] Glue two Exempt balsa (18) 2mm balsa sheet covered wood strips haste stiffener on the wing supporter. {14 1 Glues the horizontal tail wing supporter and glue the stiffener den glue servo mount numbered A7 to the fuselage. { 15 } 2MM balsa she as controvert { 16] Cribbing and glue the nose and glue ditto the fuselage.
{17} Install magnets on the battery cover aod mount, and stick the battery mount to the bulkhead of the fuselage, {18} Fasten the nothingness fuselage, install a screw haste handle for hatch hover. { 18) Glue wood sidestepping the battery compartment, dnd fix the battery fixing plate with screws.
{ 21} Joint the wing trailing edge. { 28) Lug the wing ribs and baa strips scolding to the plan. { 23) Lug the wing tps (plywood).
{24 | The leading edge of the wing (B XBmm balsa stupid. { 25 } Gamine the wing joint boxes and glue ito the wing ribs. {26 | Glue 2mm balsa cover to the upper and dower of the wings and make sure the overall cross section of the wings are horizontal. (Be sure not to twist the ribs). { 27 } The alga strips on the trailing end of the wings need to be remove minim order to balance the balsa coverings upper and lowers the trailing end of the wings.
{ 28) Glue the balsa cover forth trailing end of the wings, making sure the BY ribs are flat (otherwise the wings will connect to cage large gaps). 3 Tail {281 Install the wing ribs of the sailplane according to the plan, { 30) Glue'the balsa strips tor tail leading edge and trailing edge.
{ 31) Combination balsa pieces, and glue to the tail. {38} Pin the Bmm balsa pieces of { 22) 2mm balsa cover. elevator trailing edge on the plan. {34} Glue 10XBmm balsa strips and wing ribs.
4 Others { 88) Fix the sailplane with [89] Install mousetrapping screws and with rubber bands, rubber bands, (41) Elevatorconirolled by steel . 40 } Thereunder operated on oi wire with basis joint so that y tasting. sailplanes and elevator ¢an be fast-release | 5 Suggestions for angles and C of G settings 1). Interactivity: about 50-85% of wing chord length from the leading edge. the wing: O.degree. 3).2 degrees down thrust angle.
