Specifications

Page 9
VAC STANDARD PREAMPLIFIER SPECIFICATIONS (typical)
Type:Vacuum tube line stage with external power supply and home
theater (direct power amplifier) mode.
Options:Remote control for volume & mute
Dedicated MM phono input
Dedicated MC phono input
Line stage preamplifier:
Gain:24 dB
Maximum input signal:Essentially infinite (attenuation precedes line stage)
Main output:Inverting (you may reverse speaker connections if you wish to
compensate, or set your d/a converter to phase reversal)
Tape output:Unity gain from selector, non-inverting
Phono stage preamplifier:
Gain:37 dB (measured at tape output)
Residual noise:3 mV at output (S/N ratio approx. 69 dB)
Overload:117 mV @ 1 kHz = 8 volts RMS output
460 mV @ 10 kHz
Frequency response:RIAA +/- .25 dB
Notes:Does not invert absolute phase.
Tube compliment:
Phono option: 2 x 12AX7 low noise (early units); 3 x 12AX7 low noise (later units)
(The phono stage is located on circuit board at left side of chassis)
Line stage:2 x 12AU7/6189A & 2 x 12AX7 (line stage)
Warranty: Three years parts and labor, excluding tubes.