Installation Guide

PN 3002 Steel Legs Installation Sheet
Standard base rail and Slotted base rail instructions
Part 1: Installing steel legs to pre-drilled base rails.
Part 2: Installing steel legs to slotted base rails.
1
2
3
4 5
6
7
8
1 2 3
Legs Install Sheet.indd 16 msd 072203 Rev. 080311 © 2003-2011 Van Mark Products Corp. F559
Leave legs in folded position as they come
out of the box. Install mounting plates as
shown using #10 sheet metal screws.
Turn brake over onto it’s top. Place each leg assembly
at onto the base rails with the mounting plate toward
the center of the brake. Place leg clamps over ends of
leg tube and install into pre-drilled holes in base rails
using screws provided.
Install mounting plates into pre-drilled holes in
base rails as shown using screws provided in
kit.
Repeat Step 1 above. Leave leg folded. Slide 2 bolts into each base rail slot. Align bolts with holes in mounting plate.
Install 4 nuts nger-tight only for now.
Slide 2 more bolts into each base rail slot.
Place U clamps over leg tube ends and
install nuts nger-tight only for now.
Use chart on right to determine proper
leg placement from end of brake.
Tighten all nuts in place. Fold legs at then
upright to ensure proper installation.
24145 Industrial Park Dr., Farmington Hills, MI 48335
Toll Free No. 1-800-Van Mark Toll Free Fax 1-888-Van Mark
Local Phone No. 1-248-478-1200 Local Fax No. 1-248-478-1226
Web site: www.van-mark.com E-mail [e-mail]
TM4/4HD.........M4/4HD ............ 15”
TM6/6HD.........M6/6HD ............ 15”
TM8/8HD.........M8/8HD ............ 28”
TM10/10HD.....M10/10HD ........ 39”
TM12/12HD.....M12/12HD ........ 45”
TM14/14HD.....M14/14HD ........ 52”
TrimMaster
®
Mark I Series Distance from end
The distance below is measured from center
of the mounting plate to the end of base rails.
See
Chart
Leg Placement Chart