User Manual

www.vanco1.com
800.626.6445
6
1. Link Indicator Light (lights up when connected and transmitting signal to ethernet switch)
2. Power Indicator Light (lights up when powered up by PoE or included power supply)
3. Info Indicator Light (shows data is being sent/received over the Cat cable/RJ45 port)
4. DB9 connector for RS-232 Control Pass-Through
5. IR-TX port (connect included IR Transmitter cable for source control)
6. IR-RX port (connect included IR Receiver cable for display control)
7. Unit ID dip switches (disables browser based GUI for setting up and addressing units for IP-less setup)
8. RJ45 port (connect to ethernet switch)
9. HDMI Loop-out for cascading HDMI signal into other devices or to split out to additional display
10. HDMI IN (connect to a source)
11. Toslink Out (de-embeds/extracts digital audio from HDMI source using Toslink adapter)
12. Stereo Out (de-embeds/extracts analog audio from HDMI source using a stereo 3.5mm connector)
13. 5V Power Port (optional, connect included power supply if using a non-PoE ethernet switch or to use for
redundant power)
PANEL DESCRIPTIONS
Transmitting Unit
1
2 3
4
5 6
7
8
9
10
11 12
13