Installation manual

VO0010
14
5.7 CONNECTING THE DRAIN
12"
(305 mm)
VO0004A
VO0008
VO0011
VO0005
T O DRAIN
5. Installation (cont’d)
To install the drain fittings, punch the 2
knock-out sections located at the
bottom of the unit.
In order to keep the drain pan intact,
hand tighten the 2 plastic drain fittings to
the unit using the gaskets, washers and
nuts as shown.
Cut 2 sections of plastic tubing, about
12” (305 mm) long and attach them to
each drain fitting.
Join the 2 short sections to the “T” junction
and main tube as shown.
Make a water trap loop in the tube to
prevent the unit from drawing unpleasant
odors from the drain source. Make sure
this loop is situated BELOW the “T” as
shown. This will prevent water from
being drawn back up into the unit in case
of negative pressure. Run the tube to the
floor drain or to an alternative drain pipe.
Be sure there is a slight slope for the
run-off.
T IE - WRAP
12
3
4
5
Inside view