USER GUIDE ® VB0110 BRONZE MODELS 90H* 190H READ AND SAVE THESE INSTRUCTIONS *This product earned the ENERGY STAR® by meeting strict energy efficiency guidelines set by Natural Resources Canada and the US EPA. It meets ENERGY STAR requirements only when used in Canada. 03450 rev.
CONGRATULATIONS! You have made an excellent choice! We have prepared this User Guide especially for you. Please read it carefully to ensure you obtain full benefits from your Heat Recovery Ventilator unit. About this Guide This guide uses the following symbols to emphasize particular information: ! WARNING Identifies an instruction which, if not followed, might cause serious personal injuries including possibility of death.
1. UNIT DESCRIPTION 1 1. Filters 2. Blowers 3. Condensation tray 4. Heat recovery core 4 2 1 1 3 VB0097 1.1 SPECIFICATIONS MODEL WIDTH HEIGHT DEPTH WEIGHT ELECTRICAL SUPPLY POWER CONSUMPTION 2.
3. CONTROLS 3.1 INTEGRATED CONTROL 2 1 All units are equipped with an integrated control, located in front of the electrical compartment. Use the push button (1) to control the unit. The LED (2) will then shows on which mode the unit is in. VD0193 Refer to table below to see how to operate the unit using its integrated control.
3. CONTROLS (CONT’D) 3.2 OPTIONAL MAIN WALL CONTROLS (CONT’D) 3.2.2 BRONZE Location: Located in the busiest area of the house. Purpose: To adjust air supply and select desired indoor humidity level. % b) To turn the unit off, place selector at the OFF position. However, if optional auxiliary controls are used, they will still be active. 5°C+ 41°F+ MFO RT ZONE HUMIDITY CONTROL 20% 25% CO Adjusting the AIR SUPPLY CONTROL: a) Select speed MIN. or MAX. using switch A (as shown on diagram).
3. CONTROLS (CONT’D) 3.3 OPTIONAL AUXILIARY CONTROLS 3.3.1 Humidity Control Location: Located in the bathroom or in other locations where there is temporary humidity excess. Purpose: To eliminate excess humidity produced by showers or other periodic activities producing humidity. % ATIVE HUM ID IT REL Y F OF 20% HUMIDITY CONTROL 25% 70% 30% Adjust knob to the desired humidity level. CO M FO R T 40% CAUTION Do not select a humidity level below 30%.
4. MAINTENANCE ! WARNING In order to prevent personal injury, turn off the unit and unplug it before performing maintenance. When cleaning the unit, it is recommended to wear safety glasses and gloves. 4.1 REGULAR Air filters: The air filters are washable. Under normal conditions, we recommend to wash them every 3 months. • Use a vacuum cleaner to remove the heaviest portion of accumulated dust. • Then, wash in water and mild soap. • Let dry completely before reinstalling them in the unit.
5. TROUBLESHOOTING If you think your unit is malfunctioning, check some of the following: 1 2 TYPE OF PROBLEM Nothing works. Condensation on windows (air too humid). • • • • • • • • • • • • • • • TRY THIS... See if the unit is plugged in. See if the breaker is receiving power from the house circuit breaker. Adjust the humidity control knob as per instructions (see Section 3.). Operate the unit at maximum speed (MAX.) during activities generating excess humidity (family gatherings, extra cooking, etc.