User manual

3.2.4.2 SPRINT PROVISIONING INFORMATION (OMA-DM)

Sprint features Open Mobile Alliance Device Management (OMA-DM) which allows the cellular provider to provision the

modem.

After the account is activated by Sprint, the device will auto-provision after power is applied to the device for the first time.

First, verify on the Home page the MDN/MTN and MSID/IMSI/MIN are in the default mode. Then after 3-4 minutes, check

again that the MDN/MTN and MSID/IMSI/MIN are populated with the numbers provided by the carrier. Once this is

complete, you can move on to the next section. If auto-provisioning doesn’t occur, push the OMA-DM button to provision.

If both of these are unsuccessful, follow the steps below to deactivate auto-provisioning and enter the information

manually.

 Provisioning must occur in a non-roaming area of the Sprint network with a medium to strong signal strength.

 Select Provisioning from the side menu bar.

 Sprint is capable of automatic OMA-DM provisioning. The Auto Activation can be Enabled or Disabled. To save the

Auto Activation, click the SAVE button.

 If Auto Activation is Disabled, a manual initiation of OMA-DM can be started by clicking on the OMA-DM button

 If the auto-provisioning fails, and OMA-DM manual provisioning fails, and your outside the Sprint network, follow

the manual-entry activation steps below.

Manual-Entry Activation

 If provisioning must occur in a roaming area, make sure to have a medium to strong signal strength because

manual-entry activation will be required.

 Select Provisioning from the side menu bar.

 Input the MDN/MTN and MSID/IMSI (MIN) given by your provider.

 Put in the unlock code given by your provider.

 Click the Write MDN/MSID button.

3.2.5 PROVISIONING PROFILES (CDMA MODELS)

The Provider NAI page supports the programming of 2 profiles that may be used to login to the cellular provider's network.

It also allows the user to choose which profile is active.A provider may support alternate networks whose use is limited to

specific customers. Login information must be gathered from the provider. Be aware that incorrect parameter settings

could result in no access to the standard network, and no access to the alternate network.