Instruction Manual

ATO-400P / ATO-600P Operating Procedures
35
7.9 Erase Test Record Procedure
This procedure describes the steps to delete a single test record or all the test records stored in the
ATO Flash EEPROM.
Table 11.0 Erase Test Record Procedure
STEP ACTION ATO DISPLAY
11-1
On the RESTORE RECORD display (step 9-
2), press key #3 (ERASE RECORD) to
display the ERASE RECORD menu of
options (shown at right).
11-2
On the ERASE RECORD menu display,
press key #1 to erase a single record.
11-3
Enter the record number to be deleted then
press the “ENTER” key to confirm. Press
the “ENTER” key again to return to the main
menu.
NOTE
Press the “STOP” key to abort.
11-4
Press key #2 to erase all the stored records in
EEPROM.
NOTE
Press the “STOP” key to abort.
11-5
Press the “ENTER” key to confirm.
11-6
Press the “ENTER” key to return to the main
menu.
ERASE RECORD
1. ERASE SINGLE RECORD
2. ERASE ALL RECORDS
ERASE RECORD
NUMBER: XX
RECORD NUMBER: XX
ERASED!
ERASE ALL RECORDS!
Are you SURE?
“ENTER” TO CONTINUE
ERASING RECORDS
PLEASE WAIT
RECORDS ERASED!