Owner's manual

REV 2 CT-7500 S2 USER’S MANUAL

3.1.15. Configuring the Channel Settings

The CT-7500 S2 is available with 3, 6, or 12 contact inputs. Since most common timing

applications require the use of only 3 contact timing channels and one travel transducer

channel, there is no need to print data for more than 3 timing channels and one transducer

channel on the graphic and tabulated reports. The CT-7500 S2 is configured to print 3 contact

channels by default (channels 1, 2, and 3) and one transducer channel (transducer channel #1).

The default settings can be changed using the steps below:

NOTE

The CT-7500 S2 will always acquire data for all channels and store it in the working

memory when a test is performed.

a. Start from the “START-UP” menu:

Press the [3] key (SETUP).

b. The following screen will be displayed:

Press the [4] key (NEXT PAGE).

c. The following screen will be displayed:

Press the

[2] key (NUMBER OF CHANNELS).

d. The following screen will be displayed:

NOTE

The number of channels listed on this screen depends on the CT-7500 model.

For example, if your unit has only 3 channels (Model CT-7500 S2-3), only option

1 (3 Contacts) will be available.

NUMBER OF CHANNELS

1. 3 CONTACTS

2. 6 CONTACTS

3. 12 CONTACTS

1. SHOT DESCRIPTION

2. NUMBER OF CHANNELS

3. SET DATE & TIME

4. NEXT PAGE

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. TIME BRKR 02/21/11

2. GET RSLT 13:14:15

3. SETUP

4. DIAGNOSTICS