Instruction Manual

REV 1 DIGITMR S2 USER’S MANUAL

2. METRIC

Press the [2] key (METRIC) for Metric measurement units. The measurement

units will be set to Metric, and you will be returned to the “START-UP” menu.

3. ROTARY ENCODER

Press the [3] key (ROTARY ENCODER) if you would like to set the measurement

units for the rotary encoder.

NOTE

If a rotary encoder (transducer) is used, the correct “distance/degree”

value must be entered before timing the circuit breaker.

The following screen will be displayed:

1) ENGLISH (IN./DEG)

Press the [1] key (ENGLISH) for English measurement units. The following

screen will be displayed:

If the value displayed is not correct, press the [CLEAR] key, and then

type the desired value using the keypad. Press the [ENTER] key and you

will be returned to the “START-UP” menu.

2) METRIC (MM/DEG)

Press the

[2] key (METRIC) for Metric measurement units. The following

screen will be displayed:

INCHES/DEGREE

5.535 IN/DEG

ROTARY ENCODER

1. ENGLISH (IN./DEG)

2. METRIC (MM/DEG)