Instruction Manual

DIGITMR S2 USER’S MANUAL REV 1
47
Press any key on the keypad and you will be returned to the “START-UP” menu.
Re-start at step a.
2. CONTINUE (NO SAVE)
If you do not wish to save the test shot in memory, press the [2] key, and then
continue to step b.
f. The following screen will be displayed:
Press the [1] key (NO) to indicate that there is no insertion resistor.
g. The following screen will be displayed:
Press the
[1] key (WINDOW = 1 SEC) to select the 1-second timing window.
NOTES
• The 1-second timing window is used for breaker timing. The 10-second and
20-second timing windows are used for circuit-switcher timing.
• Using the 10 second timing window will reduce the timing resolution to 0.5
ms.
• Using the 20 second timing window will reduce the timing resolution to 1
ms.
TIMING WINDOW:
1. WINDOW = 1 sec
2. WINDOW = 10 SEC
3. WINDOW = 20 SEC
INSERTION RESISTOR?
1. NO
2. YES
SHOT SAVED