User guide

DIGITMR USER’S MANUAL REV 3
31
After all of the contacts have been closed, the following screen will be displayed:
Fully close the breaker. When the breaker is at the close position (on latch), press the
[ENTER] key to find contact wipe.
e. The test results will be printed, and you will be returned to the “START-UP” menu. A
typical “Slow-Close” test results printout is shown in Figure 11.
NOTES
• The “Slow-Close” test report can be saved in the DigiTMR’s EEPROM. Please see
section 3.8.1 for information on how to save test records.
• You can calculate contact stroke by adding the contact touch and contact wipe
distances.
Figure 11. Typical "Slow-Close" Test Results Printout
LIFT BRKR TO CLS POS
THEN PRESS “ENTER”
TO FIND CONTACT WIPE
LIFT TO CLS BRKR NOW
CONTACT 1: CLOSED
CONTACT 2: CLOSED
CONTACT 3: OPEN
LIFT TO CLS BRKR NOW