User guide

REV 3 DIGITMR USER’S MANUAL
34
3.7 Printing Test Results
After a timing test has been performed, the test results can be printed in graphical or tabulated
format on the DigiTMR’s built-in thermal printer.
3.7.1. Printing the Tabulated Test Results
To print the tabulated test results from the last test performed:
a. Start from the “START-UP” menu:
Press the [2] key (GET RSLT) to get the last test results.
b. The following screen will be displayed:
Press the [1] key (PRINT TEST RESULTS).
c. The following screen will be displayed:
Press the [1] key (INTERNAL THERMAL).
d. The following screen will be displayed while the results are being printed:
A typical tabulated test results printout for an OPEN operation is shown in Figure 12.
e. When the printer is done printing, you will be returned to the “START-UP” menu.
BUSY PRINTING
SELECT PRINTER
1. INTERNAL THERMAL
2. DISPLAY RESULTS
1. PRINT TEST RESULTS
2. PLOT FULL CHART
3. PLOT EXPANSION
4. PLOT 0 – 200MS
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS