User guide

REV 3 DIGITMR USER’S MANUAL
60
3.9.3. Printing the Breaker Test Plan Directory
Follow the steps below to print a directory of all the test plans stored in the DigiTMR’s EEPROM:
a. Start from the “START-UP” menu:
Press the [3] key (SET-UP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the
[3] key (PRINT DIRECTORY).
e. The test plan directory will be printed, and you will be returned to the “START-UP”
menu. A sample test plan printout is shown in Figure 20.
Figure 20. Typical Test Plan Directory Printout
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT DIRECTORY
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS