User guide

REV 3 DIGITMR USER’S MANUAL

c. The following screen will be displayed:

Press the

[1] key (OPEN TIMING)

NOTE

If you would like to see the current AP1 and AP2 settings, press the [3] key

(PRINT SETTINGS). The settings will be printed on the thermal printer, and you

will be returned to the “START-UP” menu.

d. The following screen will be displayed:

Press the [2] key (DIST FROM CLOSE)

NOTES

Option details

• PERCENT OF STROKE

Percent of stroke is the distance based on the percentage of the total

breaker’s stroke distance. The distance is always measured from the

starting point at the fully closed position of the breaker contacts.

• DIST FROM CLOSE

The distance from Close range is selectable from 00.0 inch to 99.99

inches or from 0.0 centimeter to 99.90 centimeters. The distance is

referenced from the contact’s closed position.

• CONTACT #1

Contact point is the distance from the contact’s closed position to the

point where it is in transition from the close-to-open or the open-to-

close position. Contact channel #1 is used for this option.

e. The following screen will be displayed:

Press the

[ENTER] key to accept the default value of 1.00 in.

If you would like to enter a different value, press the

[CLEAR] key, and then type the

new value using the numeric keypad. Press the

[ENTER] key.

OPEN ANALYSIS PT 1

DISTANCE FROM CLOSE

VALUE: 01.00 in

“ENTER” TO CONFIRM

OPEN ANALYSIS PT 1

1. PERCENT OF STROKE

2. DIST FROM CLOSE

3. CONTACT #1

1. OPEN TIMING

2. CLOSE TIMING

3. PRINT SETTINGS

4. TEST PLANS