User guide

DIGITMR USER’S MANUAL REV 3
67
3.10.4. Setting the Preferred Printing Method
The DigiTMR can be configured to either print the test results automatically after each test, or
to print them by user request. To set the preferred printing method:
a. Start from the “START-UP” menu:
Press the [3] key (SET-UP).
b. The following screen will be displayed:
Press the [4] key (NEXT PAGE).
c. The following screen will be displayed:
Press the [4] key (SET PRINT MODE).
d. The following screen will be displayed:
Press the [1] key (AUTOMATIC PRINT) if you would like reports to be printed
automatically after each test. The setting will be saved and you will be returned to the
“START-UP” menu.
Press the [2] key (BY REQUEST ONLY) if you do not want test reports to be printed
automatically after each test. The setting will be saved and you will be returned to the
“START-UP” menu. Please see section 3.7 for information on how to print test shots.
SET PRINT MODE:
1. AUTOMATIC PRINT
2. BY REQUEST ONLY
1. SHOT DESCRIPTION
2. COMPUTER ITF
3. SET CLOCK
4. SET PRINT MODE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS