User guide

REV 3 DIGITMR USER’S MANUAL
70
No “PASS” or “FAIL”
indicators on the tabulated
report.
• Test plan was not loaded before performing a test. Load a test plan
and then re-print the tabulated report.
How does one review the
current analysis setting?
• From the “START-UP” menu, press the [3] key (SETUP).
• Press the [1] key (ANALYSIS POINTS).
• Press the [3] key (PRINT SETTINGS). The current AP1 & AP2 settings
will be printed.
The transducer will not
communicate with the PC.
• Make sure the DigiTMR is in computer-control mode.
• Make sure the correct PC communication port is selected in the VCBA
software.
• Make sure the serial cable is connected properly.