User Manual

Auto‐Ohm200S3/DMOM‐200S3/DMOM‐600USER’SMANUAL REV2
26
Pressthe[START]keytostartthetest.
h. Thefollowingscreenwillbedisplayedtemporarily:

Thescreenwillbeupdatedasshownbelowwhilethecurrentisbeingrampedup:

Oncethecurrentisrampeduptotheselectedtestcurrent,theinitialtestresultswillbe
displayedandtheburn‐insequencewillbeinitiated.Thefollowingscreenwillbe
displayed:

Thecurrentwillthenberampeddownandthenthefinaltestresultswillbedisplayedas
shownbelow:


NOTES
 APass/Fail([P]or[F])willbedisplayedifyouhadenteredapassing
resistancerangeinstepb.
 Ifyouhadselectedtheautomatictestmodeinstepc,youcannow
disconnectthecablesandre‐connectthemasneeded.Atestwillbe
initiatedautomatically2secondsafterthere‐connectionissensed.
TEST RESULTS
497  p
50.01 A
BURNING IN: 04
497 
50.01 A
test in progress...
ramping current
12.30A 27
test in progress...
AUTO TEST MODE