User Manual

REV2 Auto‐Ohm200S3/DMOM‐200S3/DMOM‐600USER’SMANUAL
39 
3.5.2. Saving Test Results to a Test Record
Afterperformingatest,theuserispresentedtheoptiontosavethetestresultstotheunit’s
FlashEEPROMortoaUSBFlashDrive.Ifthetestresultsarenotsavedimmediatelyafter
performingatest,theywillstillremainintheworkingmemoryandcanbe
savedlater,aslong
asanewtesthasnotbeenperformedandtheunithasnotbeenturnedoff.Followthesteps
belowtosavethetestresultsfromtheworkingmemorytoatestrecord(thefollowing
procedurecanalsobeusedtore‐savearestoredtestrecord
toanewmemorylocationortoa
USBFlashDrive):
a. Performatestorrestoreatestrecordtotheworkingmemory(seesection3.5.3and
3.5.4),andthenstartfromthe“START‐UP”menu:

Pressthe[2]key(SETUP).
b. Thefollowingscreenwillbedisplayed:

Pressthe
[3]key(SAVE/RESTORERECORD)
c. Thefollowingscreenwillbedisplayed:


NOTE
Option5(COPYTOTHUMBDRIVE)willbelistedonlyifaUSBFlashdriveis
connectedtotheAuto‐Ohm.
Pressthe[2]key(SAVERECORD).
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
5. COPY to THUMB DRIVE
1. RECORD ID
2. REVIEW RECORD
3. SAVE/RESTORE RECORD
4. SET TIME
5. SET LANGUAGE
1.RUN TEST
2.SETUP
3.QUICK TEST
time: 14:21:34
date: 05/24/11